Die elastic deformation in hot forging by rigid-plastic finite element method > Conventional forging

본문 바로가기

Die structural analysis

Die elastic deformation in hot forging by rigid-plastic finite element method

페이지 정보

작성일posted on

본문

 


 

 Rigid die

 

Elastic die










  The figures compares the predictions of an axi-symmetric hot forging process between with and without considerations of die elastic deformation. The process does not allow any flash, that is, it is a flashless closed-die forging process. 
  Of course, grain flows of them are very close to each other. However, forming loads at the final stroke is quite different. Elastic deformation of die reduced the predicted forming load by almost 30%, compared with the rigid-die case. This is one of the reasons that predicted forming loads are considerably greater than the actual forming loads especially in closed-die forging without flash. 


KSTP Spring 2016

 


(52818) 경상남도 진주시 동부로 169번길 12 윙스타워 A동 1208호

Copyright 2007. MFRC and GNU All rights reserved.

TEL +82-55-755-7529 FAX +82-55-761-7529 MAIL [email protected]

▲ To the top